I'll be doing 200mg/mL test prop and 200mg/mL masteron prop in about 2 weeks when everything gets here using ethyl oleate.
I'll let everyone know how the brewing goes and the pain factor of the injects. |
| Reply » Conversions I will be doing |
Well I made 2 batches of each today at 200mg/mL 20mL at 2/15 BA/BB
It all went well using EO as the sole carrier made it SO easy to filter it wasn't funny, I thought there was something wrong at first it was passing through so quickly.
Now I'll just have to wait a few more weeks then I can try it and see how the pain factor is.
|
| Reply » Conversions I will be doing |
It shouldnt be painfull if your not sensetive that is because i just made test p 200mg/ml and a friend of mine tried it and said it was totaly painless and i used 2/20 ba /bb and 100% EO as carrier
|
| Reply » Conversions I will be doing |
I made all 4 bottles exactly the same, slightly over 200mg/mL (to make up for any lost or left in needles), all with 2% BA and 15% BB, and it all went perfectly.
2 days later and I took a look at them and 1 of the bottles of prop has formed crystals on the bottom so I presumed it has dropped out of solution. I'm going to reheat it under a tap and see if it will dissolve again but do you think it will stay in solution? I'm guessing it hasn't completely fallen out of solution because there's not too many crystals there, I'll try take a pic tomorrow.
I live at home atm so I try and keep as minimal amount of stuff at home as I can so once I made everything I disposed of all the left over ba/bb/EO fuck I hope this works out. Where I live its quite cold do you think this had anything to do with it? Do you think since it's crystallised in the bottle it's going to make for painful injections? Any suggestions greatly appreciated.
|
| Reply » Conversions I will be doing |
It only takes one little baby crystal to crash the whole solution. Heat it up nice and hot and shake it, be sure to dissolve every last crystal. It should hold after that given your solvent ratios. If not, just reheat as necessary.
|
| Reply » Conversions I will be doing |
I put it on a saucepan with a little bit of water and heated it up for 5 minutes and dissolved every last little crystal I could see. I'll see how this goes, do you think if it crashes again adding 1 more mL of BB would help? That would make it almost 20% BB and since the total powder I put in was 4.2g in 20mL that will bring it down to 200mg/mL from 210mg/mL
|
|
Page 1 of 2 |
Menu
Conversions I will be doing