Menu
    General discussion
    Diet discussions
    Muscle Food Recipes
    Forum about training
    Supplement discussions
    Women's discussion
    Modern sport chemistry
    Discussions about other sports
    BODYBUILDING FORUMS
    Bodybuilding discussions

  What's Going On?
There are 41 guests on-line

  Bodybuilding » Bodybuilding discussion forums » Discussions about other sports
  How long should it take?

 How long should it take?


Hey guys, I just started my fourth cycle. I've been off for about five months. I choose to do another test/deca cycle. Here's my question, I've always shot my quads, I alternate sides and try to vary the location. Since I started again it seems like its taking longer to shoot. Seems like the oil is pushing xtremely slow, it takes about 10 mins to push 2cc's. I'm using a 23g 1 1/2 in. pin and i've tried heating the barrel in warm water. Is it possible that I've built up too much scar tissue in the quads? Or am I just impatient? My legs are pretty lean, is it possible that I'm going too deep and going through the muscle with an 1 1/2 in. pin? How long should 2cc's take to push.

Thanx for the help

   Reply » How long should it take?

shoot the shoulders and the ass. is the gear different then what you had used before? and try a 21 or a 22.


   Reply » How long should it take?

Different manufact. but same source, I know the stuff is good... I just think it's pushing xtremly slow. Maybe I'll try bigger pins if you think it'll help....


   Reply » How long should it take?

i would use a 1 inch and 23 guage ..tip warm up the gear in a heating pad it will cause molicules to move and thin it out temperarely which will allow it to flow through the needle alot smoother..now dont over heat it bro..ok


Page 1 of 1

1



  Bodybuilding » Bodybuilding discussion forums » Discussions about other sports

 

BMW - BMW Forums | Steroid Abuse - abusing steroids is bad (c) 2001-2007 www.bb-forums.com
Contact us
Best lyrics - kanutouren - Drinks receipe - favourite songs - váhy