Stir until clear, more heat may be necessary, but it will ensure even filtration and nothing gets "stuck" in the filter membrane.

Just the guy i wanted to hear from .. thanks doug.
I otice when I heat it, it almost goes completly clear. as it cools the swirls re-appear. I'm using low heat off and on. Should I up the heat? I'm just affraid of over cooking it.

Thanks,
Sprt

PS: i should also note that the solution is clear, but you can still see chemicl swirl.

I generally use medium low heat, but I keep an eye on it. Any hint of smoke and it comes off the burner until the burner cools down.

The EQ came out fine ... we'll see if it holds up over the next few days. I assume all is well. I played with a bit of Winstrol as well; Made some suspension. It appeared to thicken up after a while so the next time I make more I'll leave out the PEG (used 3% PEG400, 3% BA, 3% PS80, & 24% BB).

I start again tomorrow with Test enan and Deca. I'll post up questions as they come along. I appreciate you guys chiming in. I hope to see you around tomorrow if I drop in.

Regards,
Sprt

Check it out:

So pretty! oh so pretty!

Recipe:
3% Peg400
3% BA
3% PS80
24% BB
Distilled Water

With all the talk about how trick winny is I thought I was going to experience a couple crashes at least. I didnt experience anything of the sort. I guess that's what happens when you got a good group of guys helping you make the right moves.

Just wanted to share,
Sprt