Menu
    General discussion
    Diet discussions
    Muscle Food Recipes
    Forum about training
    Supplement discussions
    Women's discussion
    Modern sport chemistry
    Discussions about other sports
    BODYBUILDING FORUMS
    Bodybuilding discussions

  What's Going On?
There are 39 guests on-line

  Bodybuilding » Bodybuilding discussion forums » Discussions about other sports
  Powdered Products

 Powdered Products


OK Folks for what it is worth,

I am doing my second cycle which I started on Monday. The base of my cycle is Test Enanthate which is pharmaceutically made. I have been using some of these powdered products as part of my cycle as well.

I have been injecting the Prop that I made from raw powder I suspected it was not working as I thought it should. I took my second injection of Enanthate on Thursday, and tonight I am starting to see some bloat from the Test Enanthate. That was a surprise cuz I have been taking Anastozole (Arimidex) which I also acquired as a powder. So it would seem that both these product may be bogus. I paid good money for them too! My concern now is that I may run into issues with gyno cuz I only have enough Colmid for my post cycle. This shit suckz! If had suspected for a minute that I might have gotten ripped off I would have went with a pharmaceutically made brand from a reputable source. Live and learn. In this case the hard way! Some fruit for thought folks. I would consider this very seriously before making an investment in your next cycle!

   Reply » Powdered Products

did you check melting points of the powders before converting?


   Reply » Powdered Products

Yes I did but I do not have a lab here at my home. I just put the powder on a frying pan and turned up the flame on the burner. I tested Winny and Prop side by side. The prop did melt relatively quickly but I can not be sure at what temp. The winny did not melt as is should not have because it does not have a melting point. Perhaps I did something wrong in the conversion.....but I followed the process to the letter! 100ML@125mg/ml. 2ml BA, 14ml BB, 12.5g Prop, Approximately 75ml oil. I stirred and heated the product then filtered it. Does that sound about right?


   Reply » Powdered Products

an oven would have worked better, or place a pot of water on the stove and a coking thermometer to measure temperature and place powders in a container say a vial and leave in water, do not let it touch the bottom of pot. has it ever crashed on you? Sounds like you got it in solution relatively easily. I had to use more solvet when making my prop.


   Reply » Powdered Products

Thanks I will give it a try....By the way , how much solvent do u use?


Page 1 of 1

1



  Bodybuilding » Bodybuilding discussion forums » Discussions about other sports

 

BMW - BMW Forums | Steroid Abuse - abusing steroids is bad (c) 2001-2007 www.bb-forums.com
Contact us
phone cards - favourite songs - Herbal preparations - bookmaker promotions - military patches