Plan of action for making testosterone enanthate into injectable for the first time

Supplies:

Testosterone enanthate, 500 grams (will only use 250g max)
Nalgene® MF75 bottle top filters (45mm, 500mL, .2µm) with Pall Supor® machV PES Membrane
Beaker (either 500mL or 1,000mL) (Bomex)
500mL Pyrex glass media bottle, 45mm top
Electric stove
60mL syringes
50mL sterile vials
Benzyl alcohol
Funnel
0.1g scale, 500g max capacity
Spoon
Grape seed or maybe walnut oil (need to get)
Brake bleeder vacuum kit (need to get)
Temperature resistant cloth to pick hot beaker off of stove (what are these called)

Making small amount first. Say, 50mL at 400mg/mL.

Use 60mL syringe and water to verify and mark where 50mL is on the beaker and the media bottle.
Measure out 20g of test enan into beaker using scale
Add 50mL*2%=1mL BA to beaker
Add oil to the beaker until it is a little less than the 50mL line
Place beaker in center of electric burner on stove. Beaker will be directly on the element
Turn on, medium-low heat
Do not go get beer or get distracted. Watch the oil. At it warms, stir with spoon.
When all hormone is dissolved, remove from heat
Oil is hot. Let stand for five minutes
Attach bottle top filter to media bottle. Attach vacuum.
Pour oil from beaker into bottle top filter and cap
Vacuum pressure of 10 Hg
Wait for oil to filter
Eliminate vacuum pressure
Add plain oil to the bottle top filter to make up for whatever needs to be added so that there is 50mL in the media bottle. This will flush remaining hormone in the bottle top filter into the media bottle.
Wait for the remaining oil to filter
Eliminate vacuum pressure
Vent vial with pin
Stick 60mL syringe into vial, remove plunger, insert funnel
Pour 50mL of oil from media bottle into syringe using funnel
Remove funnel, replace with plunger. Inject oil into vial
Get beer